[. . . ] Computer/Component Video port (blue) To computer monitor port Computer cable (accessory) Tip The computer cable supplied with the projector may not match the monitor port on some computers. In such cases, you will need to purchase a separate adapter. Connecting to a Video Source User's Guide "Connecting to a Video Source" Turn off the power for both the projector and the video source before connecting them. [. . . ] S-Video port Video port (yellow) When connecting to a video source with an S-Video output port To S-Video output port S-Video cable (commercially-available) Audio 2 port To video output port To audio output port yellow white A/V cable (accessory) red yellow white red When connecting to a video source with a video output port * To output sound from the video equipment through the projector's built-in speaker, connect the video equipment and the projector with the accessory A/V cable (white/red). If connecting a component video source (such as a DVD player), you can use the optional component video cable to connect the source to the Computer/Component Video port at the rear of the projector. User's Guide "Turning On the Projector" Tip Preparation before Projecting Power indicator 1 3 2 5 1 2 3 4 Remove the lens cover. The Power indicator will flash green, and projection will then start (warm-up in progress). If no images are projected, change the input signal. Tip Page down Page up Power Computer S-Video/Video Color Mode Menu A/V Mute Freeze E-Zoom Projector Remote control 5 If connecting to a computer with a built-in monitor, or to a laptop computer, you may need to change the output destination using the buttons or setting menus. User's Guide "Turning On the Power and Projecting Images" Adjustments Adjusting the image angle While pressing the foot adjust buttons at either side, lift up the front of the projector. When the desired angle is obtained, release the foot adjust buttons. User's Guide "Adjusting the Screen Image" Adjusting the image size and focus Fine adjustments to image size Turn the zoom ring to adjust the image size. The following tables show what the indicators mean and how to remedy problems that they indicate. Refer to "When Having Some Trouble" in the User's Guide for further details. (Warning) indicator Status Problem and remedy Lit Flashing Red Power indicator Status Lit Flashing Problem and remedy High temperature inside projector (overheating) The lamp will turn off automatically and projection will stop. Wait for about 5 minutes, unplug the power cable and then plug it back in again. If the lamp is broken replace by a new lamp, or contact your local dealer for further advise. If the temperature rises too high again, projection will stop automatically. Check that the air filter and air exhaust vent are clear, and that the internal room temperature is not too high. Orange Standby condition The power cable should only be disconnected in this condition. Cool-down in progress The projector changes to standby (indicator lights orange) after about 20 seconds. [. . . ] Check that the air filter and air exhaust vent are clear, and that the internal room temperature is not too high. Orange Standby condition The power cable should only be disconnected in this condition. Cool-down in progress The projector changes to standby (indicator lights orange) after about 20 seconds. [. . . ]